Zinc base die castings are always copper plated in cyanide baths.
锌基合金的压铸件总是在氰化镀液中镀铜.
Any out - of - adjustment pins can be reason for casting rejection.
如果顶钉调整不当,可能使铸件报废.
Antimony adds to the rigidity of the casting.
锑能增加铸件的硬度.
It's used for the production of large castings.
它用于大型铸件的制备.
All lead castings were produced at first by hand in many cases from single cavity molds.
起初所有的铅铸件都是手工生产的,而且在许多情况下都是使用单腔模具.
Ribs are sometimes add to the webs of castings to give greater strength and rigidity.
有时在铸件的腹板上加上肋条,以增强其强度和刚度.
Many blow holes exist in 495 A diesel engine block casting.
495A柴油机缸体铸件存在严重的卷入性气孔缺陷.
Each casting will be subjected to hydrostatic testing after final machining.
各个铸件将接受流体静力测试在最后用机器制造以后.
Objective To discuss the failure causes of castingremovable denture with casting prosthesis.
目的探讨口腔铸件常见失败原因.
The fabricated die verified through practice meets product requirements.
经实际验证,模具符合铸件产品要求.
Misrun is the common defects found in oven door castings process.
浇不足是焦炉炉门铸件常见铸造缺陷.
If you think this these might be restrictive, try a cast.
如果您认为这些限制性强, 可以试试铸件.
Cutting : Oxyacetylene cut off the castings from gate stick.
用氧气-乙炔焰从浇棒上切下铸件.
To eliminate cracks in the casting, the hollow sand core is applied.
为消除铸件中出现的开裂现象, 采用中空型芯以增加铸型的退让性.
Casting process design is the key step of the casting process.
铸造工艺设计是铸造生产的基本组成部分和关键环节,是能否生产出优质铸件的关键.